PRISM SDI/IP WAVEFORM MONITOR
Installation Instructions

NOTE: For use with the following PRISM products:
* MPI2-25 and MPX2-25
* MPI2-10 and MPX2-10
* MPI and MPX


PERFORM THE FOLLOWING STEPS TO UPGRADE THE INSTRUMENT FIRMWARE:

1. Copy the upgrade file with a .bin file extension from the upgrade package onto a USB memory device. You will need approximately 1.2 GB of available space on the USB device.

2. Insert the USB memory device into a USB port on the PRISM monitor.

3. On the PRISM monitor, select the Settings (gear) icon to open the Settings menu.

4. Select Utilities to open the Utilities submenu.

5. Select Firmware Upgrade. The display will list all of the files on the USB device with a .bin file extension.

6. Select the desired file in the list, and then select Install to start the upgrade.

7. While the upgrade is in process, a message box appears stating that the firmware installation is in progress.
IMPORTANT: Do not interrupt the instrument during the installation process.

8. When the upgrade is complete, the instrument will reboot and complete the installation of the upgrade.

9. Remove the USB device from the PRISM monitor.


PERFORM THE FOLLOWING STEPS TO VERIFY THE INSTRUMENT UPGRADE:

1. Select the Settings (gear) icon to open the Settings menu.

2. Select Utilities to open the Utilities submenu.

3. Select Version to open the Version display.

4. Verify that the displayed firmware version number matches the version of the firmware upgrade package you installed.

---

For product information, sales, service, and technical support:
Worldwide, visit www.telestream.net/telestream-support/video/support.htm to find contacts in your area.

V2.2
D00010031A